Installation Manual Universal Dual Sim holder Gen.3
1. Please touch a water tab or s.th similar first for grounding reasons
2. Cut the simcards
First possibility (as shown on the pictures)
Stick the adhesive label (4) on the simcard and cut along the visible line with a good pair of scissors. If everything is correct, the simcards will fit tightly into the holder (1).
|
|
|
Second possibility (as shown on the pictures)
You can just place one of the "resume cards" (3) on your simcard and draw around the hole with a pencil. This way you are saving the adhesive label (4).Cut around the line with a pair of scissors afterwards.
|
|
|
3.Put your cut simcards face down into the holder (1)
If you have sticked the adhesive label (4) onto the simcard before, please take it off first..Make sure that the cut simcards are small enough and that the contact parts are clean.
4. Close the holder (1), by fitting the cover (2) carefully on the holder (1)
|
|
5.Done!
Put the sim holder in your mobile phone instead of your regular simcard and turn on the phone.One of the two simcards should be active. We suggest to use a PIN-number for each simcard in order to identify the card. But you do not have to use PIN numbers. This also works if you do not use pin numbers. Every time you turn the phone off and on again, simcards are being switched. For most Nokia mobile phones, the quick code *3370# will make the mobile phone turn off and on again.
You can still use the cut simcard the regular "single way" by putting it into the "resume card" (3) and fixing it with the adhesive label (4) or a piece of tape. The sim holder works with every phone. You should still be careful and not take it out for no reason. Every mobile phone puts a different amount of pressure on the holder and the contact parts should not be damaged or twisted.
6. Receiving calls on both lines
In order to receive calls on both numbers at the same time, you must program a call divert:
If you want to use number A and receive calls on number B at the same time, please dial *62* number B# then turn the phone off and on again.